1 - Getting started with your NoSo One kit
barry (Administrator) 11-24-2015 at 03:43 AM.
Post: #1
This build guide covers the NoSo One Basic and Plus kits. The initial steps are identical, so if you are building the Plus version, you get the Basic version working first, and then do a few very simple modifications to create the Plus version.

You will need:
* sidecutters (to trim wires and component leads to length)
* needle-nose pliers to help bend wires and leads
* a little desk space
* about an hour
- - Quote -
barry (Administrator) 11-24-2015 at 03:50 AM.
Post: #2
Kit contents - NoSo One Basic
The kit contains everything you need to build the amplifier.

   

Start by checking the kit against this list and identifying the parts:
* 1x breadboard
* 1x LM386 chip (8 pins)
* 1x LED (red)
* 2x 330uF electrolytic capacitor
* 1x 100nF film capacitor (labelled 0.1k)
* 1x 4.7nF film capacitor (labelled 472)
* 1x 47nF ceramic capacitor (labelled 473)
* 1x 10r/0.6W resistor (brown-black-black-gold bands)
* 1x 1.2k/0.25W resistor (brown-red-red bands)
* 1x battery clip with input socket + wires
* 1x speaker + wires
* 1x PP3 battery
* red and black wire (about 10cm of each)
- - Quote -
barry (Administrator) 11-24-2015 at 03:54 AM.
Post: #3
Kit contents - NoSo One Plus
In addition to the items listed above you will have the following:
* an output socket attached to the (bigger, better) speaker
* a bag of components for tone tweaking
* a potentiometer, pre-wired, with knob
* a two-position switch, pre-wired
* 3x M4 mounting hardware for the speaker

   

Put the extra items to one side for now. You will use them after completing the Basic build.
- - Quote -
barry (Administrator) 12-07-2015 at 05:10 AM.
Post: #4
Missing parts?
If there's anything missing from your NoSo One kit, or if there's been some damage in shipping, get in touch with Amp Maker.
- - Quote -
Post Reply