Home > Control panels > Gold plexi 18W Lite panel

Gold plexi 18W Lite panel

A plexi panel to suit the popular Lite version of the Marshall 18W amp

This control panels is made of material very similar in appearance to the gold plastic used in the 1960s plexi era. This particular control layout is aimed at the 18W Lite project (based on the original '60s Marshall 18W amplifier). It would also suit any project with a stripped-down set of controls: Volume and Tone. From right to left, on the front panel, the controls are: Inputs (1 and 2); Volume; Tone; Standby; On/Off; Indicator. There's a matching rear panel available, too.

Dimensions & info

The plexi control panel are 483mm wide, 63mm tall and approx 1.5mm thick. It is sized to fit and match the plain medium chassis, punched 5x9 chassis, punched steel chassis and the punched 2x8 and 3x9 chassis.
      The control spacing is 40mm centre to centre - i.e. a total of 240mm from the indicator to the Inputs on the front panel. The holes are pre-punched to suit the mounting shafts of typical controls. Note: the centre line for the holes is slightly offset downwards (28mm from the bottom edge), so that the controls are that little bit easier to see when you're standing over your amplifier.


Price: £20.00
inc VAT
Quantity
NOTE: Amp Maker is closed for a whole year, reopening in Autumn 2019. See Home page for details.